Wright Flyer (GPMA1110)

Note #1:
Procedure for Arming the Speed Control

To start the motors on the Wright Flyer it is necessary to arm the speed control.

1. Be sure the throttle control on your transmitter is in the off position, then turn on the transmitter.
2. Hold the airplane, making sure that your hands are away from the propellers.
3. Switch on the radio in the airplane. Notice that the red LED will light solid when you turn on the radio.
4. Advance the throttle control on the transmitter to full throttle. Leave the throttle in this position until the red LED begins to flash. Move the throttle back to the off position. The LED will now be off. The speed control is now armed and ready for flight.
5. As you advance the throttle the motors will start. You are ready to fly.

This procedure must be followed before each flight.

Note #2:

Please refer to the addendum file below when you get to the following steps in the manual:

• Page 4, Parts list
• Page 6, Step 3
• Page 7, Step 2
• Page 8, steps 3 and 5
• Page 9, Step 2
• Page 9, Step 2 and 5
• Page 9, Step 1 note
• Page 9, Step 4
• Page 9, Step 6
• Page 11, Step 1

Wright Flyer ARF Addendum (38k PDF)

© 2000-2012 Hobbico, Inc. All rights reserved. Privacy Statement | Terms of Use