This item is discontinued.
Please see our airplanes index for a list of current products.

Almost Ready-To-Fly EP Aerobatic Foam Profile Plane

Go end-over-end with ease.

If you're looking for tumbling fun, the FlatOuts Reflection is your plane. Waterfalls, tumbles, and rolls are amazingly easy. With its short wing span and large ailerons, the roll rate is incredible!

Flight-ready in only 2-3 hours.
Custom hardware provides unmatched strength and performance!
Excels at low speeds and tight turns needed for flying indoors.

Fly in just 2-3 hours! Using foam-safe CA and the supplied custom hardware, you'll easily assemble the Reflection's pre-printed foam panels and carbon rods into a sturdy, great-looking 3D model.

A powerful T-370 brushed motor and gearbox are included and ready for installation. Also supplied are a slow fly propeller and prop saver that enables it to deflect at landing.
The Reflection is also available without the motor, gearbox, prop and prop saver. GPMA1140

"For just a little time and money, the Reflection offers big returns — outdoing other foam profile models in looks, construction quality, and 3D aerobatic ability."

Don Anderson
President and Founder
Great Planes Model Manufacturing

View the video clip:
26.4MB, 3.1MB, 1.5MB

Download wallpaper for your computer

Download the manual (704k PDF)

Innovative hardware for Tape-Free Assembly

Control Horns The control horns have a larger than normal hole that fits the Z-bend pushrod connector without slop. The control does double duty as a hinge, reducing weight and assuring correct linkage geometry.		Landing Gear Molded strut supports hold the 2 mm carbon rod landing gear legs in position. They're also braced at the fuselage, wing and wheels for a strong, properly reinforced landing gear.

Amazing Control Throw Large servo arms and control horns offer up to 80 degree deflection.		Clip-Hinge System Clip-Hinges allow control surfaces to pop off in a crash and avoid damage.

Z-Bends A large bearing surface on the Z-bends reduces wear to prevent slop, unlike linkage systems that rely on small wire Z-bends. To make installation simple, the 1 mm carbon rod is secured in the Z-bend with a drop of CA.		Tailwheel The tail gear pivots on the carbon fin post, allowing the snap-in tailwheel to steer the airplane while on the ground.

SPECIFICATIONS
Stock Number: GPMA1116
Wingspan: 27.5 in. (700 mm)
Wing Area: 400 in² (26 dm²)
Weight: 9.5 - 11 oz (270-310 g)
Wing Loading: 3.4 - 3.9 oz/ft² (10-12 g/dm²)
Length: 31 in (785 mm)
Includes: T-370 motor, 5:1 gearbox, prop
Requires: 4-channel radio w/3 micro servos (10 grams or less), 10-amp ESC, 3S 640mAh LiPo battery pack, charger