Riot 3D Micro ARF (GPMA1570/1571)

Posted 8/9/2006

Please follow the steps below when you get to those steps in the instruction manual.

Step 9, page 7: The Riot's rudder uses only two hinges.
Step 2, page 7: Identify the top and bottom of the bottom wing by looking through the covering and finding the slots for the wing struts. These slots are at the TOP of the bottom wing. Mark the BOTTOM of the wing. On the BOTTOM of the bottom wing only, carefully cut slots in the ailerons for the control horns in the location shown in the sketch.
Step 2, page 11: The motor is attached to the airframe using three #2x3/8 [9.5mm] screws. The hole for the motor wires is 1/8" [3.2mm] diameter.
Step 3, page 13: Make sure that the hole goes through both sides of the wheel pant. Also, the wheel hole needs to be enlarged to 1/16" [1.6mm]